Single Host Setup

This article was written for version 2.3.1 of Core. Click here for the most recent version of the help center.

PolySync Core IP address

When using a static network, the DDS Discovery feature will search for other hosts through the defined Ethernet interface. If other PolySync Core hosts exist on the network the PolySync Core bus will be shared, which means other host’s and node’s data will be visible, and vice versa. The proper way to connect two or more ECUs is through a distributed host set up.

Set Address

For a single host system with a static IP address, the following command can be used:

$ polysync-core-manager -s

This updates the low-level network configuration file telling PolySync Core which IP address is associated to the PolySync Core bus.

Feel free to use the default IP address:, or select a static IP address from a private network.

For single host systems it is highly recommended to use the loopback interface with the IP address

$ polysync-core-manager -s


One requirement for PolySync Core nodes to discover each other on the loopback interface is to enable multicast.

$ sudo ifconfig lo multicast

This is set persistently during the script during installation.

SDF IP address

Lastly, open the SDF Configurator to ensure that the SDF configuration matches the system network configuration. If there is a mismatch detected in the SDF, the Host Wizard will open.

$ polysync-core-sdf-configurator