Studio Record

This article was written for version 2.0.9 of Core. Click here for the most recent version of the help center.

The record module is used to command active runtime nodes to start and stop recording data to the hard drive.

It uses the UTC timestamp─of the moment record is pressed─to name and identify the logfile session.

In a single host system, all data is recorded and written to the same location. Runtime nodes record data on the local host they are executing on in a distributed system.

Each host has a unified rnr_logs directory where data is written to. This is defined in the SDF Configurator in the “RnR Logs” directory.

To replay the recorded data on another system, check out this Exporting Recorded Data article.